Quiet Stairs and Refinished Treads in Matthews After On-Site Inspection

What Happens When Squeaking Stairs Are Assessed Before Replacement

If you have squeaking stairs in a Matthews home built in the 1960s through the 1990s, the treads were likely built on site, nailed and glued to stringers cut from dimensional lumber. Those stairs can often be tightened by driving screws through the tread into the riser or stringer, eliminating the squeak without replacing anything. Factory-built stairs—common in newer construction along the Highway 51 corridor—use treads that are glued and stapled together in a jig. Once the glue bond fails, the tread cannot be repaired the same way, and replacement is the only option that stops the movement.

Joyces Hardwood Floors inspects the stair before anything is replaced, because on-site-built treads can often be tightened, while factory treads glued and stapled together generally cannot. The result is a stair that does not announce every footstep and a repair cost that reflects what the stair actually needs rather than a blanket replacement.

How Stair Tread Refinishing Works in Downtown Matthews Homes

In older Matthews homes with original site-built oak stairs, refinishing the treads involves sanding the existing wood down to bare material, repairing any splits or worn edges, and applying finish that matches the adjacent hardwood floor. The nosing—the rounded front edge of each tread—takes the most wear and often shows the deepest scratches. If the tread is thick enough, sanding removes those scratches and restores a flat, uniform surface. If the tread has been refinished multiple times and the remaining thickness is marginal, replacement is recommended before the nosing splits or the veneer delaminates.

Trim is handled the same way: shoe mold is pulled and replaced during refinishing, and baseboard only when damaged. The stairs are sanded in place, starting with coarse grit to level the surface and finishing with fine grit to prepare for stain and topcoat. Each tread dries individually, so the stair can be walked on within a day, though full cure takes longer. The refinished treads look consistent with the hallway floor, and the nosing edge is smooth and rounded rather than splintered.

If you have stairs that squeak, show wear at the nosing, or need refinishing in Matthews, get in touch with a specialist who inspects before quoting and explains what can be tightened versus what must be replaced.

Deciding Between Tread Repair and Replacement in Matthews

Not every squeaking or worn stair tread needs to be replaced, but the decision depends on whether the tread was built on site or assembled in a factory, and whether enough material remains to sand and refinish. The wrong repair wastes money; the wrong replacement wastes original wood.

  • Site-built treads in older Matthews homes along Stallings and Downtown Matthews that can be tightened with screws rather than replaced
  • Factory-built treads common in newer construction that cannot be disassembled or re-glued once the bond fails
  • Nosing edges worn past the veneer layer, indicating the tread is too thin to sand again without exposing substrate
  • Squeaks caused by loose risers rather than the tread itself, which can be fixed by shimming or screwing from below without touching the tread surface
  • Stain matching between refinished treads and the existing floor, which requires testing on a hidden section before committing to the full stair

Stair tread work in Matthews starts with an on-site inspection to determine what can be saved and what must be replaced. Contact a flooring specialist who evaluates the stair construction and tread thickness before recommending a repair or replacement path.